Anybody have a front and rear upper control arm laying around that they could get a couple dimensions from?
Centerline of ball joint straight back to virtual centerline if you ran a shaft through the two frame attachment points. Hope that makes sense.
Just trying to see if I can find any aftermarket tubular control arms that are the same length that I can use on a tube chassis project using G35 uprights.
Thanks In advance!
Centerline of ball joint straight back to virtual centerline if you ran a shaft through the two frame attachment points. Hope that makes sense.
Just trying to see if I can find any aftermarket tubular control arms that are the same length that I can use on a tube chassis project using G35 uprights.
Thanks In advance!
Comment